dotnetcore serilog using rolling file


serilog is a logging component for .net. To serilog into your project and configure logging from your project configuration file, here's what you need to do.

First, you need to install the following packages :-

Install-Package Serilog.Extensions.Logging -DependencyVersion Highest

Install-Package Serilog.Sinks.RollingFile

Install-Package Serilog.Settings.Configuration


In your start up,  you need to configure serilog using the following code.





Next, just add it in your log factory,



Next, see how our configuration file looks like. Here are we telling serilog to log to a folder in c:\temp.



Well, that's all you need to do to add serilog into your project.





Comments

Post a Comment

Popular posts from this blog

The specified initialization vector (IV) does not match the block size for this algorithm

Image
If you're getting  exception when trying to assigned key to a symmetric key and getting error message below :- The specified initialization vector (IV) does not match the block size for this algorithm And your code probably look like something below :- Then you need to go into debug mode and start looking into the supported size for IV as shown in diagram below :- As you can see, IV is 16 bytes, so you need to provide 16 bytes. The same goes for Key field too, if you're adding anything to it. As long as you provide a valid key size, then we're good and you're code will be ready.
Read more